What is the Method of Excavator to Reduce Noise?

As a Bucket Teeth Wholesale, share with you.

1. When using the excavator, we should strictly follow the instructions to ensure that there will be no wrong operation, so that the excavator can also be in good working condition, and there will be no noise.

2. Also, we should also check the excavator components after the end of the work every day to see if they are intact. This is because the components with more serious wear will have more serious noise.

3. Of course, in addition to observing the integrity of the components during the daily inspection, you should also check whether some components are loose, and if they are, tighten them in time.

4. Daily daily maintenance is not to be forgotten, because during the daily maintenance, we can find some potential problems, so that we can solve them, thus avoiding the possibility of excavator noise.

Excavators often encounter various working conditions in their work, and steep slopes are common:

Please note when descending:

YF Bucket Teeth

1. Be careful to clean up the stones, otherwise the small excavator on the track can only slip when praying.

2. Be slow. Don't make sharp turns on the slope (that is, the track does not turn) .This will make the single-sided track of the small excavator covered with stones and mud, and then make the track always turn.

3. Regardless of the slope, the bucket must land first. On a steep hillside, not only your feet control the speed, but also your bucket.

Fasten your seat belts. If you don’t want to break the window, let ’s fasten your seat belts.

Causes and maintenance methods of the old water temperature alarm failure of the excavator:

1. The outer surface of the water tank radiator is protected (clean external debris, clean the water tank);

2. Fan and fan belt (fan break, small excavator, belt slip);

3. Pump (bearing or shaft broken, blade does not rotate);

4. Coolant leaks in the cooling system (look for leaks);

5. Too much scale in the water tank (the filter channel is blocked, you can let the car work for a while, touch the radiator surface with your hand, the temperature difference is obvious, then the internal block, simple water washing can not solve this problem, most The situation is to replace the slot;

6. Engine liner or cylinder gasket and water jacket leak (overhaul engine);

7. The foam insulation around the engine has leaks (this is rare).

Our company also has YF Bucket Teeth for sale, please contact us.